Management Commands
505
ProSAFE M7100 Managed Switches
telnetcon timeout
Use this command to set the Telnet connection session timeout value, in minutes. A session is
active as long as the session has not been idle for the value set. The time is a decimal value from 1
to 160.
Note: When you change the timeout value, the new value is applied to all
active and inactive sessions immediately. Any sessions that have been
idle longer than the new timeout value are disconnected immediately.
no telnetcon timeout
Use this command to set the Telnet connection session timeout value to the default.
Note: Changing the timeout value for active sessions does not become
effective until the session is reaccessed. Also, any keystroke activates
the new timeout duration.
show telnet
Use this command to display the current outbound Telnet settings. In other words, these settings
apply to Telnet connections initiated from the switch to a remote system.
Default 5
Format telnetcon timeout <1-160>
Mode Privileged EXEC
Format no telnetcon timeout
Mode Privileged EXEC
Format show telnet
Modes • P
rivileged EXEC
• User EXEC
Term Definition
Outbound Telnet
Login T
imeout
The number of minutes an outbound Telnet session is allowed to remain inactive before being
logged off.
Maximum
Number of
Outbound Telne
t
Sessions
The number of simultaneous outbound Telnet connections allowed.
To Next Page
Loading...
