Switching Commands
127
ProSAFE M7100 Managed Switches
no set groupmembership-interval
Use this command to set the MLDv2 Group Membership Interval time to the default value.
set mld maxresponse
Use this command to set the MLD Maximum Response time for the system, on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a switch
will wait after sending a query on an interface because it did not receive a report for a particular
group in that interface. This value must be less than the MLD Query Interval time value. The range
is 1–65 seconds.
no set mld maxresponse
Use this command to set the max response time (on the interface or VLAN) to the default value.
set mld mcrtexpiretime
Use this command to set the Multicast Router Present Expiration time. The time is set for the
system, on a particular interface or VLAN. This is the amount of time in seconds that a switch
waits for a query to be received on an interface before the interface is removed from the list of
interfaces with multicast routers attached. The range is 0–3600 seconds. A value of 0 indicates
an infinite timeout, that is, no expiration.
Format no set mld groupmembership-interval
Mode • Interface Config
• Global Config
• VLAN Mode
Def
ault 10 seconds
Format set mld maxresponse <1-65>
Mode • Global C
onfig
• Interface Config
• VLAN Mode
F
ormat no set mld maxresponse
Mode • Global Config
• Interface Config
• VLAN Mode
Def
ault 0
Format set mld mcrtexpiretime <vlanid> <0-3600>
Mode • Global C
onfig
• Interface Config
To Next Page
Loading...
