NETGEAR ProSAFE M7100-24X - Show Sflow Pollers; Show Sflow Receivers

Utility Commands
472
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command:
(switch) #show sflow agent
sFlow Version.................................. 1.3;Netgear;1.0
IP Address..................................... 10.131.12.66
show sflow pollers
Use this command to display the sFlow polling instances created on the switch. Use “-” for range.
show sflow receivers
Use this command to display configuration information related to the sFlow receivers.
Format show sflow pollers
Mode Privileged EXEC
Field Description
Poller Data
Sourc
e
The sFlowDataSource (slot/port) for this sFlow sampler. This agent will support Physical
ports only.
Receiver Index The sFlowReceiver associated with this sFlow counter poller.
Poller Interval The number of seconds between successive samples of the counters associated with this
dat
a sour
ce.
Format show sflow receivers [<index>]
Mode Privileged EXEC
Field Description
Receiver Index The sFlow Receiver associated with the sampler/poller.
Owner String The identity string for receiver, the entity making use of this sFlowRcvrTable entry.
Time Out The time (in seconds) remaining before the receiver is released and stops sending samples to
sF
low r
eceiver.
Max Datagram
Size
The maximum number of by
tes that can be sent in a single sFlow datagram.
Port The destination Layer4 UDP port for sFlow datagrams.
IP Address The sFlow receiver IP address.
Address Type The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an IPv6
addr
es
s, the value is 2.
Datagram Version The sFlow protocol version to be used while sending samples to sFlow receiver.