Management Commands
566
ProSAFE M7100 Managed Switches
debug tacacs packet
Use the debug tacacs packet command to turn on TACACS+ packet debug.
no debug tacacs packet
Use this command to turn off TACACS+ packet debug.
tacacs-server host
Use the tacacs-server host command in Global Configuration mode to configure a
TACACS+ server. This command enters into the TACACS+ configuration mode. The
<ip-address> or <hostname> parameter is the IP address or hostname of the TACACS+
server. To specify multiple hosts, multiple
tacacs-server host commands can be used.
no tacacs-server host
Use the no tacacs-server host command to delete the specified hostname or IP address.
The <ip-address> or <hostname> parameter is the IP address or host name of the TACACS+
server.
tacacs-server key
Use the tacacs-server key command to set the authentication and encryption key for all
TACACS+ communications between the switch and the TACACS+ daemon. The <key-string>
parameter has a range of 0–128 characters and specifies the authentication and encryption key
for all TACACS communications between the switch and the TACACS+ server. This key must
match the key used on the TACACS+ daemon.
Text-based configuration supports TACACS server’s secrets in encrypted and non-encrypted
f
ormat
. When you save the configuration, these secret keys are stored in encrypted format only.
If you want to enter the key in encrypted format, enter the key along with the encrypted
Default Disabled
Format debug tacacs packet [receive | transmit]
Mode Global Config
Format no debug tacacs packet
Mode Global Config
Format tacacs-server host {<ip-address> | <hostname>}
Mode Global Config
Format no tacacs-server host {<ip-address> | <hostname>}
Mode Global Config
To Next Page
Loading...
Need help?
General