NETGEAR ProSAFE M7100-24X - Ip Address Dhcp

Routing Commands
179
ProSAFE M7100 Managed Switches
no ip address
This command deletes an IP address from an interface. The value for <ipaddr> is the IP addres
s
of the interface in a.b.c.d format where the range for a, b, c, and d is 1-255. The value for
<subnetmask> is a 4-digit dotted-decimal number which represents the subnet mask of the
interface. To remove all of the IP addresses (primary and secondary) configured on the interface,
enter the no ip address command.
ip address dhcp
Use this command to enable the DHCPv4 client on an in-band interface so that it can acquire
network information, such as the IP address, subnet mask, and default gateway from a network
DHCP server. When DHCP is enabled on the interface, the system automatically deletes all
manually configured IPv4 addresses on the interface.
no ip address dhcp
Use this command to release a leased address and disable DHCPv4 on an interface.
Parameter Description
ipaddr The IP address of the interface.
subnetmask A four-digit dotted-decimal number that represents the subnet mask of the interface
prefix-length Implements RFC 3021. Using the / notation of the subnet mask, this is an integer that
indic
at
es the length of the subnet mask. Range is 5–32 bits.
Format no ip address [<ipaddr>] {<subnetmask> | <prefix-length>}]
[secondary]
Mode Interface Config
Default disabled
Format ip address dhcp
Mode Interface Config
Format no ip address dhcp
Mode Interface Config