NETGEAR ProSAFE M7100-24X - Clear Traplog; Clear Vlan; Enable Password; Clear Port-Channel Counters

Utility Commands
406
ProSAFE M7100 Managed Switches
clear port-channel counters
Use this command to clear and reset port-channel and member flap counters for either a
specified port channel or a specified interface.
clear port-channel all counters
Use this command to clear and reset all port-channel and member flap counters for all interfaces.
clear traplog
This command clears the trap log.
clear vlan
This command resets VLAN configuration parameters to the factory defaults.
enable password
This command prompts you to change the Privileged EXEC password. Passwords are a maximum
of 64 alphanumeric characters. The password is case-sensitive. The option [encrypted] allows the
administrator to transfer the enable password between devices without having to know the
password. In this case, the <password> parameter must be exactly 128 hexadecimal characters.
Format clear port-channel {<lag-intf-num> | <unit/slot/port>} counters
Mode Privileged EXEC
Format clear port-channel all counters
Mode Privileged EXEC
Format clear traplog
Mode Privileged EXEC
Format clear vlan
Mode Privileged EXEC
Format enable password <password> [encrypted]
Mode Privileged EXEC