Utility Commands
407
ProSAFE M7100 Managed Switches
logout
This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out.
ping
Use this command to determine whether a computer with an IPv4 address or a host name that
resolves to an IPv4 address is on the network. Ping provides a synchronous response when
initiated from the CLI and web interfaces.
Using the options described below, you can specify the number and size of echo requests, the
inter
val between echo requests, and the source.
Format logout
Modes • Privileged EXEC
• User EXEC
Def
ault • The default count is 1.
• The default interval is 3 seconds.
• The default size is 0 bytes.
F
ormat ping {<address> | <hostname>} [count <count>] [interval <interval>]
[size <datagram-size>] [source {<ip-address> | <unit/slot/port> |
vlan <vlan-id> | network}]
Modes Privileged EXEC
Parameter Description
count Use the count parame
ter to specify the number of ping packets (ICMP echo requests) that
are sent to the destination address specified by the ip-address field. The range for
count is 1–15 requests.
interval Use the interval par
ame
ter to specify the time between echo requests, in seconds. Range
is 1–60 seconds.
size Use the size parame
ter to specify the datagram size, in bytes, of the payload of the echo
requests sent. Range is 0–65,507 bytes.
source Use the source parame
ter to specify the source IP address, interface, VLAN ID, or network
port interface to use when sending the echo requests packets. The range for vlan is
1–4093.
To Next Page
Loading...
