Switching Commands
22
ProSAFE M7100 Managed Switches
Port Configuration Commands
interface
This command gives you access to the Interface Config mode, which allows you to enable or
modify the operation of an interface (port).
interface vlan
This command gives you access to the vlan virtual interface mode, which allows certain port
configurations (for example, the IP address) to be applied to the VLAN interface. Type a question
mark (?) after entering the interface configuration mode to see the available options.
interface lag
This command gives you access to the LAG (link aggregation, or port channel) virtual interface,
which allows certain port configurations to be applied to the LAG interface. Type a question mark
(?) after entering the interface configuration mode to see the available options.
Note: The IP address cannot be assigned to a LAG virtual interface. The
interface must be put under a VLAN group and an IP address assigned to
the VLAN group.
auto-negotiate
This command enables automatic negotiation on a port.
Format interface <slot/port>
Mode Global Config
Format interface vlan <vlan id>
Mode Global Config
Format interface lag <lag id>
Mode Global Config
Default enabled
Format auto-negotiate
Mode Interface Config
To Next Page
Loading...
