Switching Commands
78
ProSAFE M7100 Managed Switches
lacp actor admin state longtimeout
Use this command to set LACP actor admin state to longtimeout.
Note: This command is only applicable to physical interfaces.
no lacp actor admin state longtimeout
Use this command to set the LACP actor admin state to short timeout.
Note: This command is only applicable to physical interfaces.
lacp actor admin state passive
Use this command to set the LACP actor admin state to passive.
Note: This command is only applicable to physical interfaces.
no lacp actor admin state passive
Use this command to set the LACP actor admin state to active.
Format lacp actor admin state longtimeout
Mode Interface Config
Format no lacp actor admin state longtimeout
Mode Interface Config
Format lacp actor admin state passive
Mode Interface Config
Format no lacp actor admin state passive
Mode Interface Config
To Next Page
Loading...
