NETGEAR ProSAFE M7100-24X - Isdp Timer; Isdp Enable; Isdp Advertise-V

Switching Commands
158
ProSAFE M7100 Managed Switches
isdp timer
This command sets the period of time between sending new ISDP packets. The range is given in
seconds.
isdp advertise-v2
This command enables the sending of ISDP version 2 packets from the device.
no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
isdp enable
This command enables ISDP on the interface.
no isdp enable
This command disables ISDP on the interface.
Default 30 seconds
Format isdp timer <5-254>
Mode Global Config
Default Enabled
Format isdp advertise-v2
Mode Global Config
Format no isdp advertise-v2
Mode Global Config
Default Enabled
Format isdp enable
Mode Interface Config
Format no isdp enable
Mode Interface Config