Quality of Service (QoS) Commands
264
ProSAFE M7100 Managed Switches
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify the IP
ACL.
Note: Only the access list fields that you configure are displayed.
Format show ip access-lists <accesslistnumber>
Mode Privileged EXEC
Term Definition
Rule Number The number identifier for each rule that is defined for the IP ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Match All Indicates whether this access list applies to every packet. Possible values are True or False.
Protocol The protocol to filter for this rule.
Source IP Address The source IP address for this rule.
Source IP Mask The source IP Mask for this rule.
Source L4 Port
K
e
yword
The source port for this rule.
Destination IP
Addres
s
The destination IP address for this rule.
Destination IP
Mask
The des
tination IP Mask for this rule.
Destination L4
Por
t Keyword
The destination port for this rule.
IP DSCP The value specified for IP DSCP.
IP Precedence The value specified IP Precedence.
IP TOS The value specified for IP TOS.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
Mirror Interface The slot/port to which packets matching this rule are copied.
Redirect Interface The slot/port to which packets matching this rule are forwarded.
Time Range Name Displays the name of the time-range if the ACL rule has referenced a time range.
Rule Status Status (Active/Inactive) of the ACL rule.
To Next Page
Loading...
