Quality of Service (QoS) Commands
279
ProSAFE M7100 Managed Switches
no iscsi cos
This command is to set the Quality of Service profile of SCSI flows to default.
iscsi aging time
The iscsi aging time Global Configuration mode command sets aging time for iSCSI sessions.
Behavior when changing aging time:
• When aging time is incre
ased - Current sessions will be timed out according to the new value.
• When aging time is decre
ased - Any sessions that have been dormant for a time exceeding
the new setting will be immediately deleted from the table. All other sessions will continue to
be monitored against the new time-out value.
no iscsi aging time
This command is to reset the aging time to the default.
Term Definition
traffic-class The traffic class used for assigning iSCSI traffic to a queue.
vpt/dscp The VLAN Priority Tag or DSCP to assign iSCSI session packets.
remark Mark the iSCSI frames with the configured VPT/DSCP when egressing the switch.
Format no iscsi cos
Mode Global Config
Default 5 minutes
Format iscsi aging time <time>
Mode Global Config
Term Definition
time The number in minutes a session is not active prior to its removal. (Range: 1-43,200)
Format no iscsi aging time
Mode Global Config
To Next Page
Loading...
