Quality of Service (QoS) Commands
250
ProSAFE M7100 Managed Switches
MAC Access Control List (ACL) Commands
This section describes the commands you use to configure MAC ACL settings. MAC ACLs ensure
that only authorized users have access to specific resources and block any unwarranted attempts
to reach network resources.
The following rules apply to MAC ACLs:
• The maximum number of ACLs you can create is hardware-dependent. The limit applies to all
ACLs, regardless of type.
• The system supports only Ethernet II frame types.
•
The maximum number of rules per MAC A
CL is hardware-dependent.
mac access-list extended
This command creates a MAC access control list (ACL) identified by <name>, consisting of
classification fields defined for the Layer 2 header of an Ethernet frame. The <name> parameter
is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC
access list.
If a MAC ACL by this name exists, this command enters Mac-Access-List config mode to allow
updating the exis
ting MAC ACL.
Note: The CLI mode changes to Mac-Access-List Config mode when you
successfully execute this command.
no mac access-list extended
This command deletes a MAC ACL identified by <name> from the system.
Term Definition
Interface Valid slot and port number separated by forward slashes.
Operational
St
atus
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface.
Format mac access-list extended <name>
Mode Global Config
Format no mac access-list extended <name>
Mode Global Config
To Next Page
Loading...
Need help?
General