NETGEAR ProSAFE M7100-24X - Dos-Control Tcpport; Dos-Control Udpport

Security Commands
356
ProSAFE M7100 Managed Switches
dos-control tcpport
This command enables TCP L4 source = destination port number (Source TCP Port =Destination
TCP Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with Source TCP Port =Destination TCP Port, the
packets will be dropped if the mode is enabled.
no dos-control tcpport
This command disables TCP L4 source = destination port number (Source TCP Port =Destination
TCP P
ort) Denial of Service protection.
dos-control udpport
This command enables UDP L4 source = destination port number (Source UDP Port =Destination
UDP Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with Source UDP Port =Destination UDP Port, the
packets will be dropped if the mode is enabled.
no dos-control udpport
This command disables UDP L4 source = destination port number (Source UDP Port =Destination
UDP Por
t) Denial of Service protection.
Default disabled
Format dos-control tcpport
Mode Global Config
Format no dos-control smacdmac
Mode Global Config
Default disabled
Format dos-control udppport
Mode Global Config
Format no dos-control udppport
Mode Global Config