Security Commands
341
ProSAFE M7100 Managed Switches
no ipv6 dhcp snooping trust
This command configures a port as an untrusted port.
ipv6 dhcp snooping log-invalid
This command controls filtration of the DHCPv6 logging messages for DHCPv6 snooping.
no ipv6 dhcp snooping log-invalid
This command controls filtration of the DHCPv6 logging messages by the DHCP snooping
application.
ipv6 dhcp snooping limit
This command control the rate at which the DHCP snooping messages enter an interface or range
of interfaces. By default, rate limiting is disabled. When you enable rate limiting, the rate can
range from 0 to 300 packets per second. The burst level range is 1 to 15 seconds. You configure
rate limiting on a physical port, which can be a trusted or untrusted port.
no ipv6 dhcp snooping limit
This command disables rate limiting for DHCPv6 snooping.
Format no ipv6 dhcp snooping trust
Mode Interface config
Default Disabled
Format ipv6 dhcp snooping log-invalid
Mode Interface config
Format no ipv6 dhcp snooping log-invalid
Mode Interface config
Default Disabled
Format ipv6 dhcp snooping limit {rate <packets per second> [burst interval
<seconds>] | none}
Mode Interface config
Format no ipv6 dhcp snooping limit
Mode Interface config
To Next Page
Loading...
Need help?
General