Quality of Service (QoS) Commands
259
ProSAFE M7100 Managed Switches
ip access-list rename
This command changes the name of an IP access control list (ACL). The <name> parameter is the
names of an existing IP ACL. The <newname> parameter is a case-sensitive alphanumeric string
from 1 to 31 characters uniquely identifying the IP access list.
If use the <newname> parame
ter to specify a name for an IP ACL that already exists, the
command fails.
permit (IP ACL)
and
deny (IP ACL)
These commands create a new rule for the current IP access list. Each rule is appended to the list
of configured rules for the list.
Note: The “no” form of these commands is not supported, since the rules
within an IP ACL cannot be deleted individually. Rather, the entire IP
ACL must be deleted and respecified.
Note: An implicit “deny all” IP rule always terminates the access list.
A rule might either deny or permit traffic according to the specified classification fields. At a
minimum, either every k
eyword or the protocol, source address, and destination address values
must be specified. The source and destination IP address fields might be specified using the
keyword any to indicate a match on any value in that field. The remaining command parameters
are all optional, but the most frequently used parameters appear in the same relative order as
shown in the command format.
Note the following limitations:
• M
atch-on-port ranges are not supported for egress ACLs.
• Match-on-fragments is not supported for egress ACLs.
• Rate limiting is not supported for egress ACLs.
Format ip access-list rename <name> <newname>
Mode Global Config
To Next Page
Loading...
Need help?
General