NETGEAR ProSAFE M7100-24X - Peer-Keepalive Enable; Peer-Keepalive Destination

Switching Commands
94
ProSAFE M7100 Managed Switches
no peer-keepalive timeout
This command resets the keep-alive timeout value to the default value of 5 seconds.
peer-keepalive enable
If MLAG is globally enabled, this command starts the keep-alive state machine on the MLAG
switch.
no peer-keepalive enable
This command stops the keep-alive state machine on the MLAG switch.
peer-keepalive destination
This command configures the destination IP address of the peer MLAG switch and the source IP
address for the local MLAG switch. This configuration is used by the dual control plane detection
protocol (DCPDP) on the MLAG switches. You can also use this command to configure the UDP
port through which the MLAG switch detects DCPDP messages. The configurable range for the
UDP port 1 to 65535.
After you have specified the IP addresses for the MLAG peers, you need to enter the peer
detection enable c
ommand.
Format no peer-keepalive timeout
Mode VPC Domain Config
Default Disabled
Format peer-keepalive enable
Mode VPC Domain Config
Format no peer-keepalive enable
Mode VPC Domain Config
Default UDP port number 50000
Format peer-keepalive destination <ip-address> source <ip-address>
[udp-port <port>]
Mode VPC Domain Config