NETGEAR ProSAFE M7100-24X - Capture Remote Port; Capture File Size; Capture Line Wrap

Utility Commands
442
ProSAFE M7100 Managed Switches
capture remote port
Use this command to configure file capture options. The command is persistent across a reboot
cycle.
no capture remote port
Use this command to reset the remote port to the default (2002).
capture file size
Use this command to configure file capture options. The command is persistent across a reboot
cycle. The range is from 2 to 512 Kbytes.
no capture file size
Use this command to reset the file size to the default (512Kbytes).
capture line wrap
There are two methods to configure capturing CPU packets into RAM: capture line wrap
and no capture line wrap. Use the capture line wrap command to stop automatically
capturing packets when 128 packets are saved and have not yet been displayed during the
capturing session. When capturing is in progress, unsaved, not-yet-displayed packets will not be
lost.
Default 2002
Format capture remote port <port-id>
Mode Global Config
Format no capture report port
Mode Global Config
Default 512Kbytes
Format capture file size <file-size>
Mode Global Config
Format no capture file size
Mode Global Config
Default Disabled
Format capture line wrap
Mode Global Config