Switching Commands
52
ProSAFE M7100 Managed Switches
vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces.
The modes defined as follows:
With either option, VLAN tagged frames are forwarded in accordance with the IEEE 802.1Q
VL
AN Specific
ation.
no vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces to Admit All. For Admit All
mode, unt
agged fr
ames or priority frames received on this interface are accepted and assigned
the value of the interface VLAN ID for this port. With either option, VLAN tagged frames are
forwarded in accordance with the IEEE 802.1Q VLAN Specification.
vlan port ingressfilter all
This command enables ingress filtering for all ports. If ingress filtering is disabled, frames
received with VLAN IDs that do not match the VLAN membership of the receiving interface are
admitted and forwarded to ports that are members of that VLAN.
Default all
Format vlan port acceptframe all {vlanonly | all}
Mode Global Config
Mode Definition
VLAN Only mode Untagged frames or priority frames received on this interface are discarded.
Admit All mode Untagged frames or priority frames received on this interface are accepted and assigned the
value of the int
erface VLAN ID for this port.
Format no vlan port acceptframe all
Mode Global Config
Default disabled
Format vlan port ingressfilter all
Mode Global Config
To Next Page
Loading...
Need help?
General