NETGEAR ProSAFE M7100-24X - Lldp Med All; Lldp Med Transmit-Tlv

Switching Commands
146
ProSAFE M7100 Managed Switches
lldp med transmit-tlv
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set will
be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Note: The current implementation supports one network policy: the voice
VLAN as defined by the voice vlan commands.
no lldp med transmit-tlv
Use this command to remove a TLV.
lldp med all
Use this command to configure LLDP-MED on all the ports.
Default By default, the capabilities and network policy TLVs are included.
Format lldp med transmit-tlv [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode Interface Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
network-policy Transmit the LLDP network policy TLV.
Format no lldp med transmit-tlv [capabilities] [network-policy] [ex-pse]
[ex-pd] [location] [inventory]
Mode Interface Config
Format lldp med all
Mode Global Config