EasyManuals Logo

NETGEAR ProSAFE M7100-24X Reference Manual

NETGEAR ProSAFE M7100-24X
636 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #570 background imageLoading...
Page #570 background image
Management Commands
570
ProSAFE M7100 Managed Switches
Configuration Scripting Commands
Configuration Scripting allows you to generate text-formatted script files representing the
current configuration of a system. You can upload these configuration script files to a computer
or UNIX system and edit them. Then, you can download the edited files to the system and apply
the new configuration. You can apply configuration scripts to one or more switches with no or
minor modifications.
Use the show running-config c
ommand (see show running-c
onfig on page 385) to capture
the running configuration into a script. Use the copy command (see
copy on page 410) to
transfer the configuration script to or from the switch.
You should use scripts on systems with default configuration; however, you are not prevented
from applying scripts on systems with non-default configurations.
Scripts must conform to the following rules:
Script files are no
t distributed across the stack, and only live in the unit that is the master unit
at the time of the file download.
The file ex
tension must be “.scr”.
A maximum of ten scripts ar
e allowed on the switch.
The combined size of all script files on the switch shall not exceed 2048 KB.
The maximum number of configur
ation file command lines is 2000.
You can type single-line annotations at the command prompt to use when you write test or
configur
ation scripts to improve script readability. The exclamation point (!) character flags the
beginning of a comment. The comment flag character can begin a word anywhere on the
command line, and all input following this character is ignored. Any command line that begins with
the “!” character is recognized as a comment line and ignored by the parser.
The following lines show an example of a script:
! Script file for displaying management access
show telnet !Displays the information about remote connections
! Display information about direct connections
show serial
! End of the script file!
To specify a blank password for a user in the configuration script, you must specify it as a space
within quotes. For example, to change the password for user jane from a blank password to hello,
the script entry is as follows:
users passwd jane
" "
hello
hello

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSAFE M7100-24X and is the answer not in the manual?

NETGEAR ProSAFE M7100-24X Specifications

General IconGeneral
BrandNETGEAR
ModelProSAFE M7100-24X
CategorySwitch
LanguageEnglish

Related product manuals