NETGEAR ProSAFE M7100-24X Reference Manual

Switching Commands
150
ProSAFE M7100 Managed Switches
0/10 Down Disabled Disabled Disabled 0,1
0/11 Down Disabled Disabled Disabled 0,1
0/12 Down Disabled Disabled Disabled 0,1
0/13 Down Disabled Disabled Disabled 0,1
0/14 Down Disabled Disabled Disabled 0,1
TLV Codes: 0- Capabilities, 1- Network Policy
2- Location, 3- Extended PSE
4- Extended Pd, 5- Inventory
--More-- or (q)uit
(Switch) #show lldp med interface 0/2
Interface Link configMED operMED ConfigNotify TLVsTx
--------- ------ --------- -------- ------------ -----------
0/2 Up Disabled Disabled Disabled 0,1
TLV Codes: 0- Capabilities, 1- Network Policy
2- Location, 3- Extended PSE
4- Extended Pd, 5- Inventory
(Routing) #
show lldp med local-device detail
This command displays detailed information about the LLDP data a specific interface transmits.
Format show lldp med local-device detail <slot/port>
Mode Privileged EXEC
Term Definition
Media Application
Type
Shows the applic
ation type. Types are unknown, voice, voicesignaling, guestvoice,
guestvoicesignaling, sfotphonevoice, videoconferencing, streamingvideo,
videosignaling.
Vlan ID Shows the VLAN id associated with a particular policy type
Priority Shows the priority associated with a particular policy type.
DSCP Shows the DSCP associated with a particular policy type.
Unknown Indicates if the policy type is unknown. In this case, the VLAN ID, Priority and DSCP are
ignor
ed.
T
agged Indicates if the policy type is using tagged or untagged VLAN.
Hardware Rev Shows the local hardware version.
Firmware Rev Shows the local firmware version.
Software Rev Shows the local software version.

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English