Routing Commands
195
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(netgear switch) #show routing heap summary
Heap Size....................... 92594000 bytes
Memory In Use................... 149598 bytes (0%)
Memory on Free List............. 78721 bytes (0%)
Memory Available in Heap........ 92365249 bytes (99%)
In Use High Water Mark.......... 210788 bytes (0%)
Router Discovery Protocol Commands
This section describes the commands you use to view and configure Router Discovery Protocol
settings on the switch. The Router Discovery Protocol enables a host to discover the IP address
of routers on the subnet.
ip irdp
This command enables Router Discovery on an interface.
no ip irdp
This command disables Router Discovery on an interface.
ip irdp multicast
This command configures the address that the interface uses to send the router discovery
advertisements. The address is 224.0.0.1, which is the all-hosts IP multicast address.
Memory Available in
Heap
The number of bytes in the original heap that have never been allocated.
In Use High Water
Mark
The maximum memory in use since the system last rebooted.
Default disabled
Format ip irdp
Mode Interface Config
Format no ip irdp
Mode Interface Config
Default 224.0.0.1
Format ip irdp multicast
Mode Interface Config
Parameter Description
To Next Page
Loading...
