Management Commands
520
ProSAFE M7100 Managed Switches
no username snmpv3 authentication
Use this command to set the authentication protocol to be used for the specified user to none.
The <username> is the user name for which the specified authentic
ation protocol is used.
username snmpv3 encryption
Use this command to specify the encryption protocol used for the specified user. The valid
encryption protocols are des or none.
If you select des, you can specify the required key on the command line. The encryption key
must be 8–64 characters long. If you select the des protocol but do not provide a key, the user
is prompted for the key. When you use the des protocol, the login password is also used as the
snmpv3 encryption password, so it must be a minimum of eight characters. If you select none,
you do not need to provide a key.
The <username> v
alue is the login user name as
sociated with the specified encryption. You
must enter the <username> in the same case you used when you added the user. To see the
case of the <username>, enter the show users command.
no username snmpv3 encryption
Use this command to set the encryption protocol to none. The <username> is the login user
name for which the specified encr
yption protocol will be used.
show users
Use this command to display the configured user names and their settings. This command is only
available for users with Read/Write privileges. The SNMPv3 fields will only be displayed if SNMP
is available on the system.
Format no username snmpv3 authentication <username>
Mode Global Config
Default no encryption
Format username snmpv3 encryption <username> {none | des [key]}
Mode Global Config
Format no username snmpv3 encryption <username>
Mode Global Config
Format show users
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General