NETGEAR ProSAFE M7100-24X - Show Classofservice Dot1 P-Mapping

Quality of Service (QoS) Commands
224
ProSAFE M7100 Managed Switches
no random-detect queue-parms
Use this command to set the WRED configuration back to the default.
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a whole.
Also known as rate shaping, traffic shaping has the effect of smoothing temporary traffic bursts
over time so that the transmitted traffic rate is bounded.
no traffic-shape
This command restores the interface shaping rate to the default value.
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes
for a specific interface. The <slot/port> parameter is optional and is only valid on platforms
that support independent per-port Class of Service mappings. If specified, the 802.1p mapping
table of the interface is displayed. If omitted, the most recent global configuration settings are
displayed. For more information, see Voice VLAN Commands on page 63
.
The following information is repeated for each user priority.
Format no random-detect queue-parms <queue-id-1> [<queue-id-2> ...
<queue-id-n>]
Modes • Global Config
• Interface Config
F
ormat traffic-shape <bandwidth>
Modes • Global Config
• Interface Config
F
ormat no traffic-shape
Modes • Global Config
• Interface Config
F
ormat show classofservice dot1p-mapping [<slot/port>]
Mode Privileged EXEC
Term Definition
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority value is mapped.