Routing Commands
216
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(netgear switch)# show interface dampening
Interface 0/2
Flaps Penalty Supp ReuseTm HalfL ReuseV SuppV MaxSTm MaxP Restart
0 0 FALSE 0 5 1000 2000 20 16000 0
Interface 0/3
Flaps Penalty Supp ReuseTm HalfL ReuseV SuppV MaxSTm MaxP Restart
6 1865 TRUE 18 20 1000 2001 30 2828 1500
ICMP Throttling Commands
This section describes the commands you use to configure options for the transmission of various
types of ICMP messages.
ip unreachables
Use this command to enable the generation of ICMP Destination Unreachable messages. By
default, the generation of ICMP Destination Unreachable messages is enabled.
no ip unreachables
Use this command to prevent the generation of ICMP Destination Unreachable messages.
ip redirects
Use this command to enable the generation of ICMP Redirect messages by the router. By default,
the generation of ICMP Redirect messages is disabled.
Default enable
Format ip unreachables
Mode Interface Config
Format no ip unreachables
Mode Interface Config
Default disabled
Format ip redirects
Mode • Global C
onfig
• Interface Config
To Next Page
Loading...
