NETGEAR ProSAFE M7100-24X - VLAN Commands; Vlan Database; Network Mgmt_Vlan

Switching Commands
48
ProSAFE M7100 Managed Switches
VLAN Commands
This section describes the commands you use to configure VLAN settings.
vlan database
This command gives you access to the VLAN Config mode, which allows you to configure VLAN
characteristics.
network mgmt_vlan
This command configures the Management VLAN ID.
no network mgmt_vlan
This command sets the Management VLAN ID to the default.
vlan
This command creates a new VLAN and assigns it an ID. The ID is a valid VLAN identification
number (ID 1 is reserved for the default VLAN). The vlan-list contains VlanId's in range
<1-4093>. Separate non-consecutive IDs with ',' and no spaces and no zeros in between the
range; Use '-' for range.
Format vlan database
Mode Privileged EXEC
Default 1
Format network mgmt_vlan <1-4093>
Mode Privileged EXEC
Format no network mgmt_vlan
Mode Privileged EXEC
Format vlan <vlan-list>
Mode VLAN Config