NETGEAR ProSAFE M7100-24X - DHCP Server Commands; Show Clock; Ip Dhcp Pool

Utility Commands
422
ProSAFE M7100 Managed Switches
show clock
Use the show clock command in Privileged EXEC or User EXEC mode to display the time and date
from the system clock. Use the show clock detail command to show the time zone and
summertime configuration.
DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the switch.
DHCP uses UDP as its transport protocol and supports a number of features that facilitate in
administration address allocations.
ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters DHCP pool
configuration mode.
no ip dhcp pool
This command removes the DHCP address pool. The name should be previously configured pool
name.
Format show clock [detail]
Mode User EXEC
Privileged EXEC
Term Definition
Time The time provided by the time source.
Time Source The time source type.
If option detail is specified, these terms are displayed
Time Zone The time zone configured.
Summer Time Indicate if the summer time is enabled.
Default none
Format ip dhcp pool <name>
Mode Global Config
Format no ip dhcp pool <name>
Mode Global Config