Switching Commands
26
ProSAFE M7100 Managed Switches
Link State: Down
Auto Negotiation: Enabled
Clock: Auto
1000f 1000h 100f 100h 10f 10h
----- ----- ---- ---- --- ---
Admin Local Link Advertisement no no yes no yes no
Oper Local Link Advertisement no no yes no yes no
Oper Peer Advertisement no no yes yes yes yes
Priority Resolution - - yes - - -
(Netgear Switch)#show port advertise
Port Type Neg Operational Link Advertisement
--------- ------------------------------ ----------- ------------------------------
0/1 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
0/2 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
0/3 Gigabit - Level Enabled 1000f, 100f, 100h, 10f, 10h
show port
This command displays port information.
Format show port {<slot/port> | all}
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of port. The possible values
are:
• Mir
ror - this port is a monitoring port. For more information, see P
ort Mirroring
Commands on page 100.
• PC Mbr- this por
t is a member of a por
t-channel (LAG).
• Probe - this port is a probe port.
Admin Mode The P
ort control administration state. The port must be enabled in order for it to be
allowed int
o the network. - May be enabled or disabled. The factory default is enabled.
Physical Mode The desired port speed and duplex mode. If autonegotiation support is selected, the duplex
mode and speed is set fr
om the auto-negotiation process. Note that the maximum
capability of the port (full-duplex -100M) is advertised. Otherwise, this object determines
the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status The port speed and duplex mode.
Link Status The Link is up or down.
To Next Page
Loading...
Need help?
General