NETGEAR ProSAFE M7100-24X - Lacp Partner Port Priority; Lacp Partner System ID

Switching Commands
82
ProSAFE M7100 Managed Switches
lacp partner port priority
Use this command to configure the LACP partner port priority. The valid range for <priority>
is 0–255.
Note: This command is only applicable to physical interfaces.
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
lacp partner system id
Use this command to configure the 6-octet MAC Address value representing the administrative
value of the Aggregation Port’s protocol Partner’s System ID. The valid range of <system-id>
is 00:00:00:00:00:00 - FF:FF:FF:FF:FF.
Note: This command is only applicable to physical interfaces.
no lacp partner system id
Use this command to configure the default value representing the administrative value of the
Aggregation P
ort’s protocol Partner’s System ID.
Default 0x0
Format lacp partner port priority <priority>
Mode Interface Config
Format no lacp partner port priority
Mode Interface Config
Default 00:00:00:00:00:00
Format lacp partner system id <system-id>
Mode Interface Config
Format no lacp partner system id
Mode Interface Config