Security Commands
311
ProSAFE M7100 Managed Switches
storm-control broadcast rate (Global)
Use this command to configure the broadcast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, broadcast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadc
ast storm recovery.
storm-control multicast
This command enables multicast storm recovery mode for an interface. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of multicast traffic will be limited to the configured threshold.
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
storm-control multicast level
This command configures the multicast storm recovery threshold for an interface as a
percentage of link speed and enables multicast storm recovery mode. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of multicast traffic will be limited to the configured threshold.
Default 0
Format storm-control broadcast rate <0-14880000>
Mode Global Config
Format no storm-control broadcast rate
Mode Global Config
Default disabled
Format storm-control multicast
Mode Interface Config
Format no storm-control multicast
Mode Interface Config
To Next Page
Loading...
Need help?
General