Routing Commands
205
ProSAFE M7100 Managed Switches
no ip vrrp accept-mode
This command is used to allow a router to respond to ICMP Echo Requests sent to an address on a
VRRP vir
tual router.
show ip vrrp interface stats
This command displays the statistical information about each virtual router configured on the
switch.
Format no ip vrrp <vrid> accept-mode
Mode Interface Config
Format show ip vrrp interface stats <slot/port> <vrid>
Modes • P
rivileged EXEC
• User EXEC
Term Definition
Uptime The time that the virtual router has been up, in days, hours, minutes, and seconds.
Protocol The protocol configured on the interface.
State
T
r
ansitioned to
Master
The total number of times virtual router states has changed to MASTER.
Advertisement
Rec
eived
The total number of VRRP advertisements received by this virtual router.
Advertisement
Inter
val Errors
The total number of VRRP advertisements received for which advertisement interval is
different than the configured value for this virtual router.
Authentication
Failur
e
The total number of VRRP packets received that do not pass the authentication check.
IP TTL errors The total number of VRRP packets received by the virtual router with IP TTL (time to live)
not equal t
o 255.
Zero Priority
Pack
ets Received
The total number of VRRP packets received by virtual router with a priority of '0'.
Zero Priority
Pack
ets Sent
The total number of VRRP packets sent by the virtual router with a priority of '0'.
Invalid Type
Pack
ets Received
The total number of VRRP packets received by the virtual router with invalid 'type' field.
Address List
Err
ors
The total number of VRRP packets received for which address list does not match the locally
configured list for the virtual router.
Invalid
Authentic
ation
Type
The total number of VRRP packets received with unknown authentication type.
To Next Page
Loading...
