NETGEAR ProSAFE M7100-24X - Udld Timeout Interval; Udld Message Time

Utility Commands
484
ProSAFE M7100 Managed Switches
no udld enable
This command disables udld globally on the switch.
udld message time
This command configures the interval between UDLD probe messages on ports that are in the
advertisement phase. The range is from 7 to 90 seconds.
udld timeout interval
This command configures the time interval after which UDLD link is considered to be
unidirectional. The range is from 5 to 60 seconds.
udld enable
This command enables UDLD on the specified interface.
no udld enable
This command disables udld on the specified interface.
Format no udld enable
Mode Global Config
Default 15
Format udld message time <interval>
Mode Global Config
Default 5
Format udld timeout interval <interval>
Mode Global Config
Default disabled
Format udld enable
Mode Interface Config
Format no udld enable
Mode Interface Config