Management Commands
558
ProSAFE M7100 Managed Switches
show radius
Use this command to display the values configured for the global parameters of the RADIUS
client.
The following shows example CLI display output for the command.
(Switch)#show radius
Number of Configured Authentication Servers............. 32
Number of Configured Accounting Servers................. 32
Number of Named Authentication Server Groups............ 15
Number of Named Accounting Server Groups................ 3
Number of Retransmits................................... 4
Time Duration........................................... 10
RADIUS Accounting Mode.................................. Disable
RADIUS Attribute 4 Mode................................. Enable
RADIUS Attribute 4 Value ............................... 192.168.37.60
Format show radius
Mode Privileged EXEC
Term Definition
Number of Configured
Authentic
ation Servers
The number of RADIUS Authentication servers that have been configured.
Number of Configured
Acc
ounting Servers
The number of RADIUS Accounting servers that have been configured.
Number of Named
Authentic
ation Server
Groups
The number of configured named RADIUS server groups.
Number of Named
Acc
ounting Server Groups
The number of configured named RADIUS server groups.
Number of Retransmits The configured value of the maximum number of times a request packet is
re
transmitted.
Time Duration The configured timeout value, in seconds, for request retransmissions.
RADIUS Accounting Mode A global parameter to indicate whether the accounting mode for all the servers is
enabled or no
t
.
RADIUS Attribute 4 Mode A global parameter to indicate whether the NAS-IP-Address attribute has been
enabled to use in R
ADIUS requests.
RADIUS Attribute 4 Value A global parameter that specifies the IP address to be used in the NAS-IP-Address
attribute t
o be used in RADIUS requests.
To Next Page
Loading...
Need help?
General