Management Commands
556
ProSAFE M7100 Managed Switches
radius server msgauth
Use this command to enable the message authenticator attribute to be used for the specified
RADIUS Authenticating server.
no radius server msgauth
Use the
no version of this command to disable the message authenticator attribute to be used for
the specified RADIUS Authenticating server.
radius server primary
Use this command to designate a configured server as the primary server in the group of servers
that have the same server name. Multiple primary servers can be configured for each number of
servers that have the same name. When the RADIUS client has to perform transactions with an
authenticating RADIUS server of specified name, the client uses the primary server that has the
specified server name by default. If the RADIUS client fails to communicate with the primary
server for any reason, the client uses the backup servers configured with the same server name.
These backup servers are identified as the secondary servers.
Format radius server msgauth {<ipaddr> | <dnsname>}
Mode Global Config
Field Description
ip addr The IP address of the server.
dnsname The DNS name of the server.
Format no radius server msgauth {<ipaddr> | <dnsname>}
Mode Global Config
Format radius server primary {<ipaddr> | <dnsname>}
Mode Global Config
Field Description
ip addr The IP address of the RADIUS authenticating server.
dnsname The DNS name of the server.
To Next Page
Loading...
Need help?
General