Management Commands
572
ProSAFE M7100 Managed Switches
script validate
Use this command to validate a script file by parsing each line in the script file, which you specify
with the <scriptname> parameter. The validate option is intended to be used as a tool for
script development. Validation identifies potential problems. It might not identify all problems
with a given script on any given device.
Pre-Login Banner and System Prompt Commands
This section describes the commands you use to configure the pre-login banner and the system
prompt. The pre-login banner is the text that displays before you log in at the user prompt.
copy (pre-login banner)
Use a copy command option to upload or download the CLI Banner to or from the switch. You
can specify local URLs by using TFTP, Xmodem, Ymodem, or Zmodem.
Note: <ip6addr> is also a valid parameter for routing packages that support
IPv6.
set prompt
Use this command to change the name of the prompt. The length of name might be up to 64
alphanumeric characters.
Format script validate <scriptname>
Mode Privileged EXEC
Format copy <url> nvram:clibanner
or
copy nvram:clibanner <url>
Mode Privileged EXEC
Format set prompt <prompt_string>
Mode Privileged EXEC
To Next Page
Loading...
