Security Commands
315
ProSAFE M7100 Managed Switches
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an interface and
disables unicas
t storm recovery.
storm-control unicast rate
Use this command to configure the unicast storm recovery threshold for an interface in packets
per second. If the mode is enabled, unicast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured threshold.
no storm-control unicast rate
This command sets the unicast storm recovery threshold to the default value for an interface and
disables unicas
t storm recovery.
storm-control unicast (Global)
This command enables unicast storm recovery mode for all interfaces. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold.
Format no storm-control unicast level
Mode Interface Config
Default 0
Format storm-control unicast rate <0-14880000>
Mode Interface Config
Format no storm-control unicast rate
Mode Interface Config
Default disabled
Format storm-control unicast
Mode Global Config
To Next Page
Loading...
Need help?
General