EasyManuals Logo

NETGEAR ProSAFE M7100-24X Reference Manual

NETGEAR ProSAFE M7100-24X
636 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #199 background imageLoading...
Page #199 background image
Routing Commands
199
ProSAFE M7100 Managed Switches
show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled.
Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router Redundancy
Protocol (VRRP) and to view VRRP status information. VRRP helps provide failover and load
balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on
the router.
Format show ip vlan
Modes • Privileged EXEC
• User EXEC
Term Definition
MAC Address
used by Routing
VL
ANs
The MAC Address associated with the internal bridge-router interface (IBRI). The same MAC
Address is used by all VLAN routing interfaces. It will be displayed above the per-VLAN
information.
VLAN ID The identifier of the VLAN.
Logical Interface The logical slot/port associated with the VLAN routing interface.
IP Address The IP address associated with this VLAN.
Subnet Mask The subnet mask that is associated with this VLAN.
Default none
Format ip vrrp
Mode Global Config
Format no ip vrrp
Mode Global Config

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSAFE M7100-24X and is the answer not in the manual?

NETGEAR ProSAFE M7100-24X Specifications

General IconGeneral
BrandNETGEAR
ModelProSAFE M7100-24X
CategorySwitch
LanguageEnglish

Related product manuals