Security Commands
288
ProSAFE M7100 Managed Switches
Note: Port protection occurs within a single switch. Protected port
configuration does not affect traffic between ports on two different
switches. No traffic forwarding is possible between two protected
ports.
no switchport protected (Interface Config)
Use this command to configure a port as unprotected. The groupid parame
ter identifies the set
of protected ports to which this interface is assigned.
show switchport protected
This command displays the status of all the interfaces, including protected and unprotected
interfaces.
show interfaces switchport
This command displays the status of the interface (protected/unprotected) under the group ID.
Default unprotected
Format switchport protected <groupid>
Mode Interface Config
Format no switchport protected <groupid>
Mode Interface Config
Format show switchport protected <groupid>
Mode • P
rivileged EXEC
• User EXEC
Term Definition
Group ID The number that identifies the protected port group.
Name An optional name of the protected port group. The name can be up to 32 alphanumeric
charac
ters long, including blanks. The default is blank.
List of Physical
Por
ts
List of ports, which are configured as protected for the group identified with <groupid>. If
no port is configured as protected for this group, this field is blank.
Format show interfaces switchport <slot/port> <groupid>
Mode • Privileged EXEC
• User EXEC
To Next Page
Loading...
