NETGEAR ProSAFE M7100-24X - Show Flowcontrol

Switching Commands
74
ProSAFE M7100 Managed Switches
no flowcontrol
show flowcontrol
Use this command to display the IEEE 802.3 Annex 31B flow control settings and status for a
specific interface or all interfaces. It also displays 802.3 Tx and Rx pause counts. Priority Flow
Control frames counts are not displayed. If the port is enabled for priority flow control,
operational flow control status is displayed as “Inactive”. Operational flow control status for
stacking ports is always displayed as “N/A”.
Examples:
(switch)#show flowcontrol
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
------ ------------ -------- ---------
0/1 Active 310 611
0/2 Inactive 0 0
(switch)#show flowcontrol interface 0/1
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
--------- ------- -------- -------
0/1 Active 310 611
Format no flowcontrol
Mode • Global Config
• Interface Config
F
ormat show flowcontrol [slot/port]
Mode Privileged Exec