NETGEAR ProSAFE M7100-24X - Show Iscsi; Show Iscsi Sessions

Quality of Service (QoS) Commands
280
ProSAFE M7100 Managed Switches
show iscsi
This command displays the iSCSI settings.
The following example displays the iSCSI settings:
Console # show iscsi
iSCSI enabled
iSCSI vpt is 5, remark
Session aging time: 60 min
Maximum number of sessions is 256
-----------------------------------------------------------
iSCSI targets and TCP ports:
---------------------------
TCP Port Target IP Address Name
860
3260
5000
30001 172.16.1.1 iqn.1993-11.com.disk-vendor:diskarrays.sn.45678.tape:sys1.xyz
30033 172.16.1.10
30033 172.16.1.25
show iscsi sessions
The show iscsi sessions Privileged EXEC mode command displays the iSCSI sessions.
The following example displays the iSCSI sessions:
Console # show iscsi sessions
Target: iqn.1993-11.com.disk-vendor:diskarrays.sn.45678
-----------------------------------------------------------
Initiator: iqn.1992-04.com.os-vendor.plan9:cdrom.12
ISID: 11
Initiator: iqn.1995-05.com.os-vendor.plan9:cdrom.10
ISID: 222
Format
show iscsi
Mode • Privileged EXEC
• User EXEC
Def
ault If not specified, sessions are displayed in short mode (not detailed)
Format show iscsi sessions [detailed]
Mode • Privileged EXEC
• User EXEC
Term Definition
detailed Displayed list is detailed when this option is used.