NETGEAR ProSAFE M7100-24X Reference Manual

Routing Commands
215
ProSAFE M7100 Managed Switches
show dampening interface
This command summarizes the number of interfaces configured with dampening and the number
of interfaces being suppressed.
The following shows example CLI display output for the command.
(netgear switch)# show dampening interface
2 interfaces are configured with dampening.
1 interface is being suppressed.
show interface dampening
This command displays the status and configured parameters of the interfaces configured with
dampening.
Note: The clear counters command resets the flap count to zero.
The no shutdown inter
face command resets the suppressed state to
False.
Any change in the dampening configuration resets the current penalty,
reuse time, and suppr
essed state to their default values, meaning 0, 0,
and FALSE respectively.
Format show dampening interface
Mode Privileged EXEC
Format show interface dampening
Mode Privileged EXEC
Parameter Description
Flaps The number times the link state of an interface changed from UP to DOWN.
Penalty Accumulated Penalty.
Supp Indicates whether the interface is suppressed or not.
ReuseTm Number of seconds until the interface is allowed to come up again.
HalfL Configured half-life period.
ReuseV Configured reuse-threshold.
SuppV Configured suppress threshold.
MaxSTm Configured maximum suppress time in seconds.
MaxPenalty Maximum possible penalty.
Restart Configured restart penalty.

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English