NETGEAR ProSAFE M7100-24X - Port-Based Network Access Control Commands; Clear Dot1 X Statistics; Clear Radius Statistics; Dot1 X Eapolflood

Security Commands
291
ProSAFE M7100 Managed Switches
Port-Based Network Access Control Commands
This section describes the commands you use to configure port-based network access control
(802.1x). Port-based network access control allows you to permit access to network services
only to and devices that are authorized and authenticated.
clear dot1x statistics
This command resets the 802.1x statistics for the specified port or for all ports.
clear radius statistics
This command is used to clear all RADIUS statistics.
dot1x eapolflood
Use this command to enable EAPOL flood support on the switch.
no dot1x eapolflood
This command disables EAPOL flooding on the switch.
dot1x guest-vlan
This command configures VLAN as guest vlan on a per port basis. The command specifies an
active VLAN as an IEEE 802.1x guest VLAN. The range is 1 to the maximum VLAN ID supported by
the platform.
Format clear dot1x statistics {<slot/port> | all}
Mode Privileged EXEC
Format clear radius statistics
Mode Privileged EXEC
Format dot1x eapolflood
Mode Global Config
Default Disabled
Format no dot1x eapolflood
Mode Global Config
Default disabled
Format dot1x guest-vlan <vlan-id>
Mode Interface Config