NETGEAR ProSAFE M7100-24X - Network Ipv6 Enable; Network Ipv6 Address

Management Commands
576
ProSAFE M7100 Managed Switches
network ipv6 enable
Use this command to enable IPv6 operation on the network port.
no network ipv6 enable
Use this command to disable IPv6 operation on the network port.
network ipv6 address
Use this command to configure an IPv6 global address, enable or disable stateless global address
autoconfiguration, and enable or disable dhcpv6 client protocol information for the network port.
You can configure multiple IPv6 addresses on the network port.
no network ipv6 address
Use this command to:
• Remove the manually configured IPv6 global address on the network port interface (with the
address option).
• Disable the st
ateless global address autoconfiguration on the network port (with the
autoconfig option).
• Disable the dhcpv6 client pro
tocol on the network port (with the dhcp option).
Default enabled
Format network ipv6 enable
Mode Privileged EXEC
Format no network ipv6 enable
Mode Privileged EXEC
Format network ipv6 address {<address>/<prefix-length> [eui64] | autoconfig
| dhcp}
Mode Privileged EXEC
Term Definition
address IPv6 prefix in IPv6 global address format.
prefix-length IPv6 prefix length value.
eui64 Formulate IPv6 address in eui64 format.
autoconfig Configure stateless global address autoconfiguration capability.
dhcp Configure dhcpv6 client protocol.