Management Commands
544
ProSAFE M7100 Managed Switches
snmp-server enable traps violation
Use this command to enable sending new violation traps designating when a packet with a
disallowed MAC address is received on a locked port.
Note: For other port security commands, see Protected Ports Commands on
page 287.
no snmp-server enable traps violation
Use this command to disable sending new violation traps.
snmp-server enable traps
Use this command to enable the Authentication Flag.
no snmp-server enable traps
Use this command to disable the Authentication Flag.
Note: This command might not be available on all platforms.
Default disabled
Format snmp-server enable traps violation
Mode Interface Config
Format no snmp-server enable traps violation
Mode Interface Config
Default enabled
Format snmp-server enable traps
Mode Global Config
Format no snmp-server enable traps
Mode Global Config
To Next Page
Loading...
