Utility Commands
476
ProSAFE M7100 Managed Switches
llpf blockall
Use this command to block LLPF protocol(s) on a port. Use blockall to filter all PDUs with a
DMAC of 01:00:00:0C:CC:CX on the interface. Use
blockisdp to filter the ISDP packets on the
interface. Use
blockvtp to filter the VTP packets on the interface. Use blockdtp to filter the
DTP packets on the interface. Use
blockudld to filter the UDLD packets on the interface. Use
blockpagp to filter the PAGP packets on the interface. Use blocksstp to filter the SSTP
packets on the interface.
no llpf
Use this command to unblock LLPF protocol(s) on a port.
show llpf interface all
Use this command to display the status of LLPF rules configured on a particular port or on all
ports.
Default Disable
Format llpf {blockisdp | blockvtp | blockdtp | blockudld | blockpagp |
blocksstp | blockall}
Mode Interface Config
Format no llpf {blockisdp | blockvtp | blockdtp | blockudld | blockpagp |
blocksstp | blockall}
Mode Interface Config
Format show llpf interface [all | <slot/port>]
Mode Privileged EXEC
Term Definition
Block ISDP Shows whether the port blocks ISDP PDUs.
Block VTP Shows whether the port blocks VTP PDUs.
Block DTP Shows whether the port blocks DTP PDUs.
Block UDLD Shows whether the port blocks UDLD PDUs.
Block PAGP Shows whether the port blocks PAGP PDUs.
Block SSTP Shows whether the port blocks SSTP PDUs.
Block All Shows whether the port blocks all proprietary PDUs available for the LLDP feature.
To Next Page
Loading...
Need help?
General