Utility Commands
471
ProSAFE M7100 Managed Switches
sflow source-interface
Use this command to specify the physical or logical interface to use as the sFlow client source
interface. The address of the source Interface is used for all sFlow communications between the
sFlow receiver and the sFlow client. If the configured interface is down, the sFlow client falls back
to normal behavior.
no sflow source-interface
Use this command to reset the sFlow source interface to the default settings.
show sflow agent
The sFlow agent collects time-based sampling of network interface statistics and flow-based
samples. These are sent to the configured sFlow receivers. Use this command to display the sFlow
agent information.
Format sflow source-interface {<unit/slot/port> | loopback <loopback-id> |
tunnel <tunnel-id> | vlan <vlan-id>}
Mode Global Config
Parameter Description
unit/slot/port The VLAN or port-based routing interface.
loopback-id The loopback interface that you want to use as the source IP address. The range of the
loopback ID is from 0 t
o 7.
tunnel-id The tunnel interface that you want to use as the source IP address. The range of the tunnel ID
is from 0 t
o 7.
vlan-id The VLAN interface that you want to use as the source IP address. The range of the VLAN ID
is from 1 t
o 4093.
Format no sflow source-interface
Mode Global Config
Format show sflow agent
Mode Privileged EXEC
Field Description
sFlow Version Uniquely identifies the version and implementation of this MIB. The version string must have
the following s
tructure: MIB Version; Organization; Software Revision where:
• MIB V
ersion: ‘1.3’, the version of this MIB.
• Organization: Netgear.
• Revision: 1.0
IP Addr
ess The IP address associated with this agent.
To Next Page
Loading...
