Quality of Service (QoS) Commands
263
ProSAFE M7100 Managed Switches
ip access-group
This command either attaches a specific IP ACL identified by <accesslistnumber> to an
interface or associates with a VLAN ID in a given direction. The parameter <name> is the name of
the access control list.
An optional sequence number might be specified to indicate the order of this IP access list
relativ
e to other IP access lists already assigned to this interface and direction. A lower number
indicates higher precedence order. If a sequence number is already in use for this interface and
direction, the specified access list replaces the currently attached IP access list using that
sequence number. If the sequence number is not specified for this command, a sequence number
that is one greater than the highest sequence number currently in use for this interface and
direction is used.
no ip access-group
This command removes a specified IP ACL from an interface.
acl-trapflags
This command enables the ACL trap mode.
no acl-trapflags
This command disables the ACL trap mode.
Default none
Format ip access-group {<accesslistnumber> | <name>} {{control-plane | in |
out}| vlan <vlan-id> {in | out}} [sequence <1-4294967295>]
Modes • Int
erface Config
• Global Config
Def
ault none
Format no ip access-group {<accesslistnumber> | <name>} {{control-plane |
in | out}| vlan <vlan-id> {in | out}} [sequence <1-4294967295>]
Mode • Interface Config
• Global Config
Def
ault disabled
Format acl-trapflags
Mode Global Config
Format no acl-trapflags
Mode Global Config
To Next Page
Loading...
