Quality of Service (QoS) Commands
262
ProSAFE M7100 Managed Switches
icmp-type and icmp-code, or
icmp-message
Note: This option is available only if the protocolkey is icmp.
Specifies a match condition for ICMP packets.
Either specify the ICMP type and optional ICMP code, or specify the
ICMP mes
sage.
• icmp-t
ype. The IP ACL rule matches on the specified ICMP message
t
ype. Specify the icmp-type keyword and enter a number from 0 to
255.
• icmp-c
ode. The IP ACL rule matches on the specified ICMP message
c
ode. Specify the icmp-code keyword and enter a number from 0 to
255.
• icmp-message. This selec
tion enables bo
th the ICMP type and ICMP
code. Specify the icmp-message keyword and enter one of the
following message options:
- echo, echo-reply, host-redirect, mobile-redirect, net-redirect,
ne
t-unr
eachable, redirect, packet-too-big, port-unreachable,
source-quench, router-solicitation, router-advertisement,
time-exceeded, or ttl-exceeded and unreachable.
The ICMP message option is decoded into the corresponding ICMP
type and ICMP c
ode within that ICMP type.
fragments Specifies that IP ACL rule matches on fragmented IP packets.
precedence, tos and tosmask, or dscp Specifies the ToS for an IP ACL rule, depending on a match of the
pr
ec
edence value, ToS value with optional ToS mask, or DSCP value.
You must specify the keyword and a value, for example, precedence 7.
time range Lets you impose a time limitation on the ACL rule as defined by the
time-r
ange-name par
ameter, which is a name that you have defined
with the time-range command.
If a time range with the specified name exists and the ACL that contains
the rule is applied t
o an int
erface or bound to a VLAN, the ACL rule is
applied when the time range becomes active. The ACL rule is removed
when the time range with specified name becomes inactive.
If a time range with the specified name does not exist and the ACL the
rule is applied to an int
erface or bound to a VLAN, the ACL rule is
applied immediately.
log Specifies that this rule must be logged.
assign-queue Specifies the assign queue, which is the queue identifier (queue-id) to
which pack
e
ts that match this permit rule are assigned.
The value of the queue identifier (queue-id) is 0-(n-1), in which n is
the number of user-c
onfigur
able queues on the switch.
mirror or redirect Specifies either the mirror interface or the redirect interface, which is
the slot and por
t (unit/slot/port) to which packets that match this rule
are copied or forwarded, respectively.
rate-limit
Specify traffic rate limiting by entering the allowed rate of traffic in
kbps and the burst size in kbytes.
Parameter Description
To Next Page
Loading...
