NETGEAR ProSAFE M7100-24X - Set Igmp Querier Query-Interval

Switching Commands
121
ProSAFE M7100 Managed Switches
Note: The Querier IP Address assigned for a VLAN takes preference over
global configuration.
The IGMP Snooping Querier application supports sending periodic general queries on the VLAN to
solicit membership repor
ts.
no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional address
parame
ter to reset the querier address to 0.0.0.0.
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in
seconds that the switch waits before sending another general query.
no set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time to its default value.
Default disabled
Format set igmp querier [<vlan-id>] [address <ipv4_address>]
Mode • Global Config
• VLAN Mode
F
ormat no set igmp querier [<vlan-id>] [address]
Mode • Global Config
• VLAN Mode
Def
ault disabled
Format set igmp querier query-interval <1-18000>
Mode Global Config
Format no set igmp querier query-interval
Mode Global Config